Skip Navigation


Kent publishes its better broadband roll-out plan
Friday 01 November 2013 08:30:35 by Andrew Ferguson

Kent County Council has published its maps for the project to bring superfast broadband to a good chunk of the counties premises. The maps split the roll-out into eight phases covering January 2014 to December 2015 when the project should complete.

The maps reveal initially the current picture and a progress chart to show what sort of benefit each phase should be, alas the maps are a pretty low resolution squeezing Kent into 640 x 453 pixels so it will be impossible to identify individual villages.

Phase Date %'age with fibre based option
One Jan 2014 - June 2014 78%
Two April 2014 to Sept 2014 81%
Three July 2014 to Dec 2014 84%
Four Oct 2013 to March 2015 87%
Five Jan 2015 to June 2015 90%
Six April 2015 to Sept 2015 92%
Seven July 2015 to Dec 2015 96%
Eight July 2015 to Dec 2015 96%
No extra fibre based services as this last phase will be delivery of basic USC level service

Kent CC had intention of reaching a figure of 91% of premises with a superfast broadband option and by pushing fibre based coverage to 96% this allows for the variation in speed due to distance from the cabinet for the predominantly FTTC based roll-out.

As with other counties the slowest and most rural areas are left to the end, and while very annoying one presumes the County and BT is gambling on the project delivering under budget or showing high uptake and thus allowing funding to go further into the rural areas with fibre based services.

Update 14:30 There is a postcode checker on the Kent website but be aware rather than drilling down to the full postcode it returns a result for a wider area, e.g. TN15 0SN will give results for all TN15 0SA through to TN15 0SZ postcodes.

Comments

Posted by gmoorc over 3 years ago
There is a post code checker on their site but I have to question its accuracy.

For CT187P it is saying Phase 2, work to commence between 04/14 and 09/14 however all but 2 of the cabinets are already installed and powered and one of those is being done this week.
Posted by R0NSKI over 3 years ago
I just tried the postcode checker once I'd found it, for a cabinet I know wasn't planned.

It seems to strip the last letter from the postcode, so it is not very accurate at all, I know other cabinets in that are are enabled.It did say that area is planned for Phase 7 and work should start between July 2015 and November 2015. So Percy Avenue Kinsgate looks like it still has two years to wait.
Posted by Plankton1066 over 3 years ago
You have to laugh at the resolution of the maps. Kent & BDUK have given BT £19.5M and instead of a "plan" of what they are going to get for this massive pile of cash, they get a map pulled out of a road atlas coloured in by a child.
Posted by andrew (Favicon staff member) over 3 years ago
The postcode checker drops the last digit e.g. type in TN15 0SN and it will return results for the larger TN15 0SA to TN15 0SZ range.
Posted by Michael_Chare over 3 years ago
The only good thing about the maps is that they show a few main roads.
With regards to the post code checker, it returns results for post code sectors, which in the above example would be TN15 0
Posted by timmay over 3 years ago
The checker appears to strip off the last TWO letters.

The same result, and number of properties is gives for ME13 9A, ME13 9P and ME13 9S!

No accuracy at all and subject to change!
Posted by lenham343 over 3 years ago
While superfast won't be going into a lot of the North Downs in these plans - it seems it will be available out in the Thames estuary!! (Phase 7, north of the Isle of Grain)
Posted by mrartist over 3 years ago
I already have fibre (Canterbury) but looked at the postcode checker and it says after roll out: "100% of premises should get fibre/superfast broadband" and "0% of premises should get basic broadband". It seems wrong to say no one can get basic broadband?

I then tried their speedchecker link (via www.broadbandspeedchecker.co.uk) which gives a completely wrong result showing 23Mbits down and 7Mb up. My service is 80/20 and actual results are close to that (70/18). If I go directly to broadbandspeedchecker (not through KCC page), I get 374Mbits down and 15 up - 374 download, I wish !!!
Posted by mgsport over 3 years ago
I agree that this information on its own is not that useful but www.doogal.co.uk (provides UK coverage) can provide a CSV download of the numbers of households at postcode sector level which is within the ball park number provided by BT.

Using the above example of TN15 0

see http://www.doogal.co.uk/UKPostcodes.php?Search=TN15%200

However what I found great was that a KML file can also be downloaded and subsequently uploaded into Google Earth to provide a much more interesting pictorial view of the postcodes.
You must be logged in to post comments. Click here to login.